Cross Technologies 2015-58T Manual de instrucciones descargar pdf (Pagina 10)

2.4 Installation / Operation

2.4.1 Installing and Operating the 2015-58 Upconverter

1. Connect a -35 dBm to -10 dBm, 70 MHz signal to IF IN, J4 (Figure 2.2)

2. Connect RF OUT, J5, to the external equipment.

3. Connect 100- 240 ±10% VAC, 47 - 63 Hz to AC input on the back panel.

4. Set the desired output frequency (See Section 2.5 Menu Settings).

5. Set the input level (See Section 2.5 Menu Settings).

6. Set the gain for +0 to +30 dB. Make sure the output stays within -20 to 0 dBm with the

gain selected and the input level provided. (See Section 2.5 Menu Settings).

7. Be sure DS6 (green, DC Power) is on and DS2 (red, Alarm) is off (Figure 2.3).

8. AC Fuse - The fuse is a 5 mm X 20 mm, 2 amp slow blow (Type T) and is inserted in the far slot

in the drawer below the AC input as shown in Figure 2.4. There is a spare fuse in the near slot.

If a fuse continues to open, the power supply is most likely defective.

AC Fuse - 2 amp slow blow (Type T),

5 mm X 20 mm

FUSE DRAWER

SPARE FUSE

INPUT

100-240± 10%VA

47-63 Hz

2A MA

FUSE

TYPE T 2A GDC

250 VOLT

FOR 100 - 240 V~

FIGURE 2.4 Fuse Location and Spare Fuse

2015-58 Manual_Rev. F Page 10 06/10/14

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Cross Technologies 2015-58T Manual de instrucciones Pagina 10